3 Stage fuel filtration for Series 4000 CX1/CX2/CX3/CX5/SX1/SX3/TX5/G73.
Rolls-Royce Soluitions is pleased to announce that the standard of the fuel filtration strategy for all Mining and Oil&Gas engines has been changed to a 3-Stage filtration setup.
Field experence and field tests have proven that this is the way to go in order to satisify customer experence, extended lifetime of vital engine components and reduce total cost of ownership.
Attached is the Application letter containing a table to show comparsion between old and new standard over all Mining and Oil&Gas engines.
Related Articles
2000 C_S_G / PLD version double skin HP fuel pipe recommendations - drill rigs / mining
Technical department, and MTU via attached old bulletin have been recommending for years now to promote the use of the “Double Skin HP fuel system” for some very key benefits to the customer – Less likely for any HP fuel pipe failure to occur - ...
S4000L61/62 Gas: Failures of Tecjet and diagnosing
It has been established that Tec jet components on S4000L61/62 Gas engines have a higher-than-expected failure rate. Branches supporting these installations should review their Tec jet stock levels and consider approaching customers to replace the ...
Oil consumption as a % of fuel burn
MTU often calculates oil consumption as a % of fuel burn. For example all the series 4000 engines generally are between 0.3% of fuel burn after 100hrs of operation to 1.0% of fuel burn. To calculate this you will need to start an oil consumption ...
Oil Level Sensor Calibration OM936 and monitoring
Too high or too low engine oil level can lead to serious damage to the engine. Hence, it is important to check it regularly and maintain with appropriate level. There are mainly two methods to check engine oil level. Oil level measurement using oil ...
MTU 4000 Gas Oil life + condition based monitoring
Please refer to the attached documents regarding the oil life + condition based monitoring