Can Bus communication Between SAM and Woodward Controller
We have a site where the ECU7 is communicating with Woodward Easygen 3200XT via can bus.Speed biasing is functioning ok as well as visualiasation for pressure, temperature, speed.The Red and Yellow alarms and SPN codes are not shown on the woodward controller.Woodward have checked the firmware and configuration file and these are thought to be correctly set up.Is this a function that needs to be enabled in the SAM or ECU.The unit is currently located at PPS Hazelmere branch and is due to be shipped Friday 9/8 Solution:Hello,Attached is a breakdown of naviagating your way through the settings on the SAM mini dialogue.Below is the setpoint which needs to be enabled for j1939 when communicating out of the x23 plug on the SAM, via the slot 3 ccb card.The default password for the SAM is: acdc, however all this can be found in the attachment..