Code SM262 on Series 400 Gas and CD200 ignition controller troubleshooting
Check through the attached ignition controller manual.Also check cranking speed, this fault can occur if the speed is not high enough to give the controller the signal it expects: we should be seeing close to 200RPM. If we don't make that then check battery voltage and if necessary voltage at the starting under cranking conditions.
Related Articles
4000-03 Injector troubleshooting
To prevent misdiagnosis TSD 20-10 Issue 2 has been developed, it contains troubleshooting procedures when dealing with injector open load faults (ADEC code #'s 341 - 360).
Fault Codes,error code, error, alarm, CPC, MCM, ACM
Fault Codes,error code, error, alarm, CPC, MCM, ACM
ADEC fault code 83 logic and troubleshooting.
Attached is a logic and troubleshooting procedure for fault finding low common rail fuel pressure in ADEC controlled S4000 engines.
S4000L61/62 Gas: Failures of Tecjet and diagnosing
It has been established that Tec jet components on S4000L61/62 Gas engines have a higher-than-expected failure rate. Branches supporting these installations should review their Tec jet stock levels and consider approaching customers to replace the ...
1000 - 1500 Series Fault code list
Please find attached the most recent fault code list for the 1000 - 1500 series engines.