Connection of service tool to MM7 Controller
In order to make configuration changes to the MM7 controller a service tool needs to be connected , the correct drivers to use for this are located at the following link
You will need to download and install genset workbench and usb-can drivers , it is preferable to install these drivers on a stand alone computer as they are not yet on the approved software list.
Information on the CAN - USB convertor can be found on the attached Document PHG7-CEM7 ( Page 54 )There are also instructions for accessing parameters via the controller directly.
Access code for MM7 is 8103
Related Articles
DEIF service code reset
ResetCode for maintenance Alarm is"2002" The maintenance alarm you are seeing is one of twopossible standard 'maintenance' timers in the DEIF controller. It is normallyset for 365 days (alarm 1) or 500 hours running (alarm 2). It can beturned off if ...4000 barring over tool
Hi Scott, If you search the attached Tool Catalogue MTU document M004029 for "barring" you'll find it. Tool Catalogues for MTU engines are all available on the MTU Business Portal, if you don't have access you can request itat theIT department. Best ...Assistance Required with Configuration of DIEF Controller
Assistance required with configuration of the Dief Controller to allow for single unit operation with no main and circuit breaker controlHarness connector, terminals and tooling repair support details for ADEC ECU 7 8 9
Attached document provides useful part numbers and details for parts and tooling required to repair or maintain ADEC ECU 7, 8 & 9 harnesses.VM diagnostic tool issues
You can have connection issues when first using / installingthe VM diagnostic tool on you laptop. Attached documents will help resolve this issue. Main issue is when opening the tool The solution is that when running the VM Tool software, instead of ...