DDEC Re-programming Uploads to Mainframe
As part of the DDEC re-programming procedure it is not often known to complete the re-programming a upload of the current calibration to the mainframe is required to ensure the most recent version calibration (customer settable options) is available for future downloads if required, therefore eliminating the need to manually reset the customer settable options.After the re-programming is complete the DDEC re-programming station is to be connected to the mainframe (the same way you download a calibration) and select the "Upload History" tab to complete the process. This now ensures the most recent version calibration is copied to the mainframe ready for future downloads. See attached procedure.
Related Articles
DDECII programming instructions
Refer attached file for DDEC-II programming instructions.
DDEC III ECM part number options - 02TS3
Attached lists options for DDEC III / DDEC 3 ecm versions available - note some maybe more specific to S60 with only 6 injector drivers (lower cost) whilst the 8 cyl version would still be suitable etc.. Refer attached for details.
Uploading DDEC Calibration to the Mainframe
After any re-programming has been completed on DDEC controlled units the latest calibration must be uploaded to the mainframe to ensure the latest (most current) calibration is available for download when required. NOTE: its always good practice to ...
DDEC III to DDEC IV / 3 to 4 conversion - 03TS06
Attached are details if a DDEC III calibration has been made available to convert / upgrade to a DDEC IV. There is no real technical benefit to change to DDEC IV from DDEC III unless struggling to obtain a DDEC III replacement ECM etc.. Note if this ...
DDEC IV ecm supersession change
Confirmation from DTNA that below changes are available as supersessions for common DDEC IV ecm’s we use. They are like for like and only below differences. 23529309 to 23565215 – typical S4000 23529308 to 23565214 – typical S60 / S2000 Changes made ...