FW: Bellevue Gas Mixture starting issue.

Have discussed this with MTU, the best way forward will be to make sure the tune from 0-40% load is richer as per the MTU map around 450 PPM this will give a better response to leaner gas at idle without comprimising the engine and will also be ok in normal operation.

Related Articles
S4000L61/62 Gas: Failures of Tecjet and diagnosing
It has been established that Tec jet components on S4000L61/62 Gas engines have a higher-than-expected failure rate. Branches supporting these installations should review their Tec jet stock levels and consider approaching customers to replace the ...
Issue with starting air compressor
Series 60 / 6063HK33 - hard starting with air compressor load at cranking.The best applicable calibration to use for these S60 Air compressor drill rigs where they don't allow the air compressor to unload at engine crank is below. This 550hp ...
Difficulty starting in automatic mode at Monash University Melbourne
Please see attached file showing conditions required to start the 4000 series gas generator at Monash university in Melbourne
Requesting part number for mixture cooler end caps.
Attached photos of part numbers XP52611400091 and XP52611400090 and Assembly instructions
CSA / QGC - 400 gas gensets @ Bellevue & Argyll
Checked in with branch, customer has been quoted for 20,000hr service.Likely in 6-8 weeks.

FW: Bellevue Gas Mixture starting issue.

FW: Bellevue Gas Mixture starting issue.

Related Articles

S4000L61/62 Gas: Failures of Tecjet and diagnosing

Issue with starting air compressor

Difficulty starting in automatic mode at Monash University Melbourne

Requesting part number for mixture cooler end caps.

CSA / QGC - 400 gas gensets @ Bellevue & Argyll