Generator set surging

Generator set surging

Flickering Screen and Can Bus signals: Can Bus cable being run without shielding and tied to the BUSsensing cables. (whether or not this is a one off I’m unsure)When the GenCircuit Breaker closes Can Bus issues occur due to interference from the bus sensing.Also faulty oil pressure alarms etc. fixed by firmware update attached. Hunting of generator set fixed by combination of firmware update and re-routing of can bus cables. Note speed demand was over CAN Bus

    • Related Articles

    • Generator Set Selection Process

      Description The purpose of to this bulletin is to give technical staff a basic understanding on the selection of engine and alternator combination to form a generator set (genset) that is sized to create 37kVA of electric capacity, Prime (3B) rated. ...

    • Vertus / SDMO / Kohler generator set coolant level sensor

      Vertus / SDMO / Kohler generator set coolant level sensor

    • What Forms do I need to commission an MTU engine or Onsite Energy generator set?

      MTU forms for Commissioning (for all engine types) can be found on the Business Portal by following this menu tree:Parts & Service / Documents / Forms and then click "Forms for Commissioning".For MTU Onsite Energy sets, there is a Cover Sheet and two ...

    • Set E start faliure on start fail over testing.

      Hi Team, Site (B2)has three gensets. We have a engine not starting on a start fail over on Set E at B2 for next DC. It is isolated to the one set only, sets D & E are fine. With bothbattery isolators on the engine starts every time. I can confirm the ...

    • S4000 Turbocharger surging

      Turbocharger surging where one turbo speed increases and one decreases, a wave pattern in noted on Diasys recording. This can be a little as 50 rpm and up to 300 rpm. Air inlet temperatures before turbocharger increases, exhaust temperature before ...