Issue with starting air compressor

Issue with starting air compressor

Series 60 / 6063HK33 - hard starting with air compressor load at cranking.The best applicable calibration to use for these S60 Air compressor drill rigs where they don't allow the air compressor to unload at engine crank is below. This 550hp calibration - 06N04M7307 has additional "start table fuelling" to overcome the load air compressors can apply at initial cold start up / cranking etc..

    • Related Articles

    • Sauer Compressor Commercial Marine Literature

      Sauer literature is available via this OneDrive link below, which allows access to a folder maintained by Off Highway Technical Support. Literature is provided for the use of Penske. Please seek permission from Nathan Newham before sharing literature ...

    • Starting Options for MTU engines

      To find different Starting Options for MTU engines: go to the MTU Business Portal > Applications & Products > Powergen > Diesel Engines > Option bookOr click the following link: ...

    • 16V4000M70 Start Air Pressure and Volume Specifications

      See attached Technical Sales Document, section 15 for all of the pressure and volume specifications for start air requirements.

    • FW: Bellevue Gas Mixture starting issue.

      Have discussed this with MTU, the best way forward will be to make sure the tune from 0-40% load is richer as per the MTU map around 450 PPM this will give a better response to leaner gas at idle without comprimising the engine and will also be ok in ...

    • Difficulty starting in automatic mode at Monash University Melbourne

      Please see attached file showing conditions required to start the 4000 series gas generator at Monash university in Melbourne