Onslow Power Station - Tooling and Recommended Spares
Hi Sebastian, I would Start with the below tooling as a minimum for the Gas engines , hopefully you have ordered some of these with the engines as you may have been able to get a discount.You will also need to follow up with Julian as we have been in contact with Regards to MIP and Diasis Dongles that will be required for the gas Engines on site.There is also going to be a requirement for the guys to have Laptops with Diasis Software IXXAT Can-USB convertors and Software installed and the appropriate dongle to access the Diesel ECU as well.As far as critical spares goes I will take a look on the business portal and get some sort of list started but I also need some information on the way the units were packaged.There is likely to be some OEM installed equipment such as fans and pumps that we will also need to include.Do you have any information from the packager that I can review? - IC920 Serial cable - GET-cable PN: X00E50200057- X00E50800013: F-Series Bypass (cable & RS232-TTL converter) (at site, for Phase 3)- X00E50206958: Tec jet-cable - Strope Lamp (PN 08600001026 or similar)- Emissions Analyzer (Madur GA40T with NOx Sensor and O2 sensor)- Scope meter (Fluke 124, PN: 08600006002) with ignition pickup 1000:1 (08600006005) and/or Motortech Spark Monitor (PN 08600006006) Regards Tony Vassallo