4000-01 DDEC High Altitude to Standard configuration differences

4000-01 DDEC High Altitude to Standard configuration differences

Within our region we have no need for 4000 mining DDEC engines to operate at High Altitude however if ever engines are imported via OEM's as high altitude configuration there are basics required to be performed to enable suitable operation within our normal altitude ie.- suitable calibration change- change high altitude turbochargers to suitable standard turbos- re-install and connect B Bank TBS (Turbo Boost Sensor)- disconnect and remove Barometric Sensor (Located beside CCPS) Refer attached.

    • Related Articles

    • Summary of Material Standards & Surface Finish Standard for drawings

      Every drawing created within the Penske Engineering department should state the material required for every part requiring fabrication on the drawing. The AS/NZS of the material should be stated in the notes of the drawing so the ...

    • DDEC Calibration settings - Hitachi EH3500AC3

      Attached is example of standard original supplied DDEC calibration set up for EH3500AC-3 haul truck. Below is summary of original factory supply. MODEL: T1237K33 (12V4000C21) Tier 1 / EO APPL GROUP:   06N04C0781    DESCRIP:  APPL DDEC C&I ELEC DRV ...

    • DDEC Calibration settings - Hitachi EH5000AC3

      Attached is example of standard original supplied DDEC calibration set up for Hitachi EH5000AC-3 haul truck. Below is summary of original factory supply. MODEL: T1637K11  (16v4000C31)  APPL GROUP:   06N04C0781    DESCRIP:  APPL DDEC C&I ELEC DRV ...

    • DDEC Calibration setting - Hitachi EH4000AC3

      Attached is example of standard original supplied DDEC calibration set up for Hitachi EH4000AC-3 haul truck. Below is summary of original factory supply. MODEL: T1637K33  (16v4000C21) Tier 1 / EO APPL GROUP:   06N04C0781    DESCRIP:  APPL DDEC C&I ...

    • Connecting to DDEC reports with Nexiq USB link II

      Connecting to DDEC Reports using Nexiq USB link II. Due to change of plug pinout from Nexiq 1 (15 pin female) to Nexiq 2 (26 pin male) must use locally developed patch cable 124032A.OTH between the Nexiq II adaptor (green) and the marine specific MIM ...