12v4000 injector install tool

12v4000 injector install tool

I am a little confused on the tool requested so I have covered off both,Below is a snapshot of the injector sleeve extraction / fitting tool.Below is the tool for removal and installation of the fuel injector.Let me know if needing anything further.NOTE: For future reference the tooling catalogues are located on the BP here - Parts & Service / Documents / MTU Onsite Energy / Tools Catalogs.

    • Related Articles

    • Connection of service tool to MM7 Controller

      In order to make configuration changes to the MM7 controller a service tool needs to be connected , the correct drivers to use for this are located at the following link Software & drivers (vandaele-power.be) You will need to download and install ...

    • 4000 barring over tool

      Hi Scott, If you search the attached Tool Catalogue MTU document M004029 for "barring" you'll find it. Tool Catalogues for MTU engines are all available on the MTU Business Portal, if you don't have access you can request itat theIT department. Best ...

    • Different Engine tune up procedure for DDEC V Series 60 engines.

      DDEC V series 60 engines require a different tune up procedure to the old legacy series 60 engines.In the attached documents are the correct procedures for completing the engine tune up and also setting the N3 fuel injectors.

    • 4000Cx1/2 HP Fuel Line Internal Slotted Nut Tool & Tension

      To minimise future fuel leakage from the HP fuel lines between the common rail and the injector on 4000 Cx1 & Cx2 engines after removing the HP line, the internal nut tension must be checked using tool F30452578 - Slotted Nut Driver. During the ...

    • 4000-03 Injector troubleshooting

      To prevent misdiagnosis TSD 20-10 Issue 2 has been developed, it contains troubleshooting procedures when dealing with injector open load faults (ADEC code #'s 341 - 360).