MTU drawing No: 0182504901

• Related Articles

• Drawing Revision Triangle

  After each revision change on a Penske Off-Highway Engineering drawing, a description of the changes required are to be recorded in the revision table. A Design Change Request (DCR) may be required if the change is major. To make the changes easier ...

• Penske Off-Highway Engineering Drawing Guide

  When drawings are created and approved for the first time (Revision A), they should have the following comments to confirm that the drawings are approved. · Part drawing Revision A description: RELEASED FOR MANUFACTURE · Assembly Drawing Revision A ...

• MTU Specifications for Liquid Fuels - (Diesel)

  MTU specifications for liquid fuels (Diesel) can be found in the Fluids and Lubricants Specifications manual.  Section 5. Liquid Fuels has all of the required information needed when evaluating fuel type and quality for MTU engines.  Attached is a ...

• Preheater setpoints for MTU Onsite Energy Gensets

  If a customer wishes to lower the set point of the jacket heaters on MTU OE gensets, for example to lower the base standby load of the installation, then there will normally be a Limit alarm in the ECU that will trigger if the temperature falls too ...

• MTU Onsite Energy S1600 genset parts information

  Available parts interpreting information on MTU Onsite Energy Series 1600 packaged gensets has been compiled by Technical Support and is included in a ZIP file in the Off-Highway Technical Documentation Sharepoint site here.