Engine run in procedure

Run in procedure for repaired engines

This document is mainly intended for S2000 and S4000 MTU engines but can be adapted across any series engine.
Follow the directions of TSD 17-10 for correct bed in of engine components after a major repair or cylinder kit replacement.

    • Related Articles

    • new engine Run-In initial oil Daimler / OM and MTU LPR

      Daimler manufactered engines ie. OM legacy & MTU LPR models are typically supplied new from factory with oil already providing preservation benefit and is considered suitable as an initial "Run In" oil capable to 1st scheduled service event. Below ...

    • Different Engine tune up procedure for DDEC V Series 60 engines.

      DDEC V series 60 engines require a different tune up procedure to the old legacy series 60 engines.In the attached documents are the correct procedures for completing the engine tune up and also setting the N3 fuel injectors.

    • Resetting run time of ADEC injectors with Diasys

      Diasys run time re-set process when replacing ADEC injectors

    • Mercedes Engines and Biodiesel

      Attached document covers the requirements for running on DIN EN 14214 compliant FAME.   Customer should be made aware of the oil change interval recommendations from Mercedes which are significantly reduced, and the requirements if the engine is ...

    • Extending oil change interval on MTU engines.

      As a result of increasing demand from within the industry a oil interval extension procedure has been developed. TSD 16-05 outlines the procedure to establish if an extension on oil change interval is achievable without having detrimental effects on ...