Assistance Required with Configuration of DIEF Controller

• Related Articles

• New SAM unit configuration (Intial Setup)

  Please see attached PDF for initial setup of SAM.

• Can Bus communication Between SAM and Woodward Controller

  We have a site where the ECU7 is communicating with Woodward Easygen 3200XT via can bus.Speed biasing is functioning ok as well as visualiasation for pressure, temperature, speed.The Red and Yellow alarms and SPN codes are not shown on the woodward ...

• Kerys Controller Manuals

  PPS are no longer a distributor for the Kohler Marine and Industrial products within Australia and for any Kohler product technical support we can refer customers or our technicians directly to Ty Martin of Clarke Energy: TyMartin| Service/Technical ...

• 4000-01 DDEC High Altitude to Standard configuration differences

  Within our region we have no need for 4000 mining DDEC engines to operate at High Altitude however if ever engines are imported via OEM's as high altitude configuration there are basics required to be performed to enable suitable operation within our ...

• Code SM262 on Series 400 Gas and CD200 ignition controller troubleshooting

  Check through the attached ignition controller manual.Also check cranking speed, this fault can occur if the speed is not high enough to give the controller the signal it expects: we should be seeing close to 200RPM.  If we don't make that then check ...