coolant thermostat design changes 2000 & 4000
LSB 16-07 available in Onedrive highlights details pertaining to MTU continuous improvements made to coolant thermostats in use on 4000 & 2000 series engines.
Related Articles
Blocked open thermostats
When performing EPQ or any heat / cooling system testing it is requried to install blocked open thermostats - most our thermostats utilised are of similar design and see attached showing example of spacer length generaly required and where to install ...
2000CR Coolant Pump to HP Fuel Pump driver
LSB 11-23 Issue 4 contains info and part numbers to determine driver type needed depending on various Coolant Pump and HP Fuel Pump versions and configurations.
Penske Off-Highway Engineering - Design Change Request (DCR)
A DCR should be summitted if any changes with the initial scope have changed on the project. If there are major changes to a project compared to the initial submitted RFES, a new RFES form should instead be summited. A DCR should only be submitted ...
12V183TE93 - Coolant drain Locations - Coolant Pump Removal
See attached information regarding draining the coolant and removing the coolant pump.Also attached is the complete operators manual for your future refence.
12V2000C21 coolant heater inlet and outlet points
The recomended coolant heater inlet and outlet points for 12V2000C engines as shown in attached photo. C06 and C09 on the drawing.