DEC 4000 will not display oil pressure or temperature

DEC 4000 will not display oil pressure or temperature

PPS are no longer a distributor for the Kohler Marine and Industrial products within Australia and for any Kohler product technical support we can refer customers or our technicians directly to Ty Martin of Clarke Energy: TyMartin| Service/Technical Support – Kohler Clarke EnergyTy.Martin@clarke-energy.com t: +61882902100 m: +61437101729 www.clarke-energy.com Problem was identified as a wiring issue as the DEC4000 Controller had been installed in place of a DEC 1000See attached DEC 4000 Drawing Plug J3M and check connections

    • Related Articles

    • Oil Level Sensor Calibration OM936 and monitoring

      Too high or too low engine oil level can lead to serious damage to the engine. Hence, it is important to check it regularly and maintain with appropriate level. There are mainly two methods to check engine oil level. Oil level measurement using oil ...

    • 4000 ECU7 Rail Oil Refill Pressure Sensor Wiring

      The optional oil replenishment system pump pressure sensor is not listed on the standard MTU rail sensor harness schematics. The pin allocations are as follows: Sensor Plug End ADEC End Pin 1 --> Pin 47 Pin 2 --> Pin 70 Pin 3 Blank Pin 4 --> Pin 48

    • Oil consumption as a % of fuel burn

      MTU often calculates oil consumption as a % of fuel burn. For example all the series 4000 engines generally are between 0.3% of fuel burn after 100hrs of operation to 1.0% of fuel burn. To calculate this you will need to start an oil consumption ...

    • MTU oil level monitoring, regulating and replenishment level managment system

      MTU offers a mechanical optional system that can provided at new engine supply :- - oil level monitoring only. - oil level monitoring, regulation and replenishment system. This version maybe found on many 4000 and 2000 installations including Marine, ...

    • Gear Box unstable oil temperature readings

      If the gear box temperature readings are unstable in a Smartline installation, and you have checked that the PT1000 gear box temperature sender is good, the next step isto disconnect the temp sender cores from Smartline LOP ( or CCU ) gear box ...